www.lifesizewalldecals.com
Installation Instructions Once you receive your Life Size Wall Decal, open the tube and lay out your graphic on a flat surface for about 12 hours. This allows it to relax after its long travel. Once the Life Size Wall Decal has relaxed, it is time to get to work. Below are the recommended tools to assist in your installation of your Life Size Wall Decal: Window Cleaner Application Hard Card Masking Tape Tape Measure Scissors Step 1: Prep the wall Step 3: Create a hinge Step 4: Application Allow the top half of the graphic to hang over the hinge. While the top half is hanging, begin peeling the top half of the backer/liner. Continue to peel the top half of the backer/liner until you reach the hinge. Cut the backer/liner just above the hinge line. Use the application card and slowly begin making horizontal strokes as you apply the graphic to the wall. Use medium pressure. You should begin at the hinge and work your way up to the top of the graphic. Be sure you do not have any creases in your graphic. Once the top half is installed, remove the masking tape hinge and also remove the bottom half of the backer/liner. Be sure to hold the graphic away from the wall during this process. Use the application card to apply the bottom half of the graphic. Again use slow horizontal strokes with medium pressure.
Clean Wash Cloth
Use a clean wash cloth and window cleaner to clean off any dust or grime from the wall. Ensure the wall is dry before applying the graphic. Step 2: Line up the graphic on the wall
Cut 2 tabs of masking tape about 2 inches in length and place them at the top of graphic corners and adjust according to your likeness.
Place a long piece of masking tape along the center horizontal axis that extends about 3" to 4" over on both sides of graphic. (This will create a hinge)